Medial displacement followed by quarter crack

Discussion in 'Shoeing Horses with Lameness Issues' started by scruggs1, Jan 14, 2013.

  1. Offline

    Justin Decker Active Member

    Likes Received:
    103
    Trophy Points:
    43
    Do you have any proof? There is no such thing as everyone or all of them in horseshoeing.

    How does a foot with a generally compromised blood supply grow 3 times faster? I've found they usually grow a little slower in certain areas until you get things lined out.

    What is a normal foot?
  2. Offline

    Justin Decker Active Member

    Likes Received:
    103
    Trophy Points:
    43
    Because you keep beating the same dead horse about the x-rays, he told you he had requested them but did not have them at this time.
  3. Offline

    Mr. Perry Active Member

    Likes Received:
    108
    Trophy Points:
    43
    Loaded up one that had minumal displacement. I can load up about a hundred with different severities. Scruggs has shown what to LOOK FOR when circumstances negate rads. Some people have to be "hand held"!:confused:
  4. Offline

    Eric Russell Active Member

    Likes Received:
    125
    Trophy Points:
    43
    Maybe not in your world but in my world the front have of the hoof capsule holds p3 off the ground. If 2/3 of it are compromised, that's a problem.
  5. Offline

    Mr. Perry Active Member

    Likes Received:
    108
    Trophy Points:
    43
    In my world the toe just gets in the way. The caudual potrion of the foot is the business end. Where is most lamness diagnosied in the foot? ooppps! My bad:confused:
  6. Offline

    Eric Russell Active Member

    Likes Received:
    125
    Trophy Points:
    43
    Probably explains why you have so much lameness in your business.

    I didn't go on fact checker or anything but I'd be willing to bet most diagnosed lameness is at the toe or by a nail.
  7. Offline

    Tom Bloomer Well-Known Member

    Likes Received:
    223
    Trophy Points:
    63
    Just some food for thought. This is where I wound up with a stable baseline after chasing the foot around for 3 or 4 cycles. She is a high $$$$$ dumblood half breed crossed with one of these . . . [IMG]
  8. Offline

    scruggs1 Active Member

    Likes Received:
    72
    Trophy Points:
    28
    What do you mean by this?



    The medial toe is where the displacement is according to the white line. If I fit the dorsal wall there instead of cheating it, I would be placing shoe beyond where the foot would be if it's laminae were not compromised...essentially fitting a flare...and adding more leverage over an area that is already suffering.

    So are you saying you fit the toe in laminitic cases? I guess I don't follow you here.
  9. Offline

    scruggs1 Active Member

    Likes Received:
    72
    Trophy Points:
    28
    This one has a bit of that as well. :)
  10. Offline

    Tom Bloomer Well-Known Member

    Likes Received:
    223
    Trophy Points:
    63
    Maybe it is difference in terminology?

    I think of caudal foot "syndrome" as something that is undiagnosed = root cause undetermined. Getting a definitive diagnosis may involve greater expense - MRI ain't cheap.

    Lameness in the toe is easier to diagnose definitively due to having fewer variables that are easier (and cheaper) to isolate and check in the field with rads, nerve blocks, and hoof testers.
  11. Offline

    Tom Bloomer Well-Known Member

    Likes Received:
    223
    Trophy Points:
    63
    Is her name "Rosie?" LOL!
  12. Offline

    Eric Russell Active Member

    Likes Received:
    125
    Trophy Points:
    43
    I think it comes down to dressing as much wall as we can without completely compromising the integrity. You can always modify the shoe to reduce leverage while also utilizing the wall for support.



    Yes and No. Leverage and fit are two separate things.

    I think you can take a messed up foot and set the shoe back and make good progress. Depending on the foot and what's going on I think the good process will stop after awhile and you will need to use the wall to make further process.

    In the foot you've shown I believe setting the shoe back adds extra stress to the compromised medial toe quarter. I would expect the foot to settle, most likely right in the medial quarter where it's already compromised.
  13. Offline

    scruggs1 Active Member

    Likes Received:
    72
    Trophy Points:
    28
    photo copy 4 cropped.jpg

    This wall was dressed then rounded at the toe. You think that was over done to the point of compromising the integrity?

    Agreed. Any attachment (shoe) and subsequent modification thereof changes the vectors in the foot.

    This was my goal here.

    What specifically do you see that gives you this opinion? I didn't think I over dressed the wall or set the shoe back too far...not saying I disagree with your line of thinking, I just don't see that being the case on this foot...but I might be wrong.
  14. Offline

    Eric Russell Active Member

    Likes Received:
    125
    Trophy Points:
    43
    Let me clarify, I've mainly been concentrating on the medial toe quarter fit. I responded to your question about setting shoes back off the toe and I believe it's the same principle as the toe quarter but it wasn't really what I was focusing on.



    The first solar pic of post #1 shows the medial wall dress fairly thin.

    Then you go onto say:

    I think thinning the wall and cheating the medial toe set that area of the foot up for failure.
  15. Offline

    scruggs1 Active Member

    Likes Received:
    72
    Trophy Points:
    28
    I removed as much flare as I felt confident to take...dressing is flare is thinning the wall, is it not? Fit the shoe to where I thought it would have the best mechanical advantage for the compromised foot. Rounded the toe off instead of dressing it down further to leave mass of wall.

    I guess time will tell if this protocol set this foot up for failure. I don't think so...but that is my opinion.

    I'll keep posting the pics; good, bad, or indifferent.
    • Like Like x 1
    • Agree Agree x 1
    • List
  16. Offline

    Justin Decker Active Member

    Likes Received:
    103
    Trophy Points:
    43
    ImageUploadedByTapatalk1358354894.242121.jpg
  17. Offline

    Eric Russell Active Member

    Likes Received:
    125
    Trophy Points:
    43
  18. Offline

    david a hall Moderator

    Likes Received:
    265
    Trophy Points:
    83
    I have to go and drink beer tonight, so quickly I will explain. If trimming wont allow then I alter the shoe to mirror the desire of the foot.If you start with a pieace of 7/8/7 /16 or 12 mm for the medial heel (a half heart bar would be good) down to 6mm medial toe 3mm lateral toe and 9mm lateral heel.
    P3 in this capsule is like a lemon on a squeezer. The Palmer angle has a wide range between upper and lower movement (palmer angle should be viewed in its dynamic state not static) and with the torsion of P3 inside the capsule the range of movement of the palmer angle is different between medial and lateral wing of P3. This is to do with the center of mass having a wide abaxial movement (Body role) with the ginglimus joint holding the lower bone colunm rigid, the capsule deforms beyond its elastic capabilities. Laminal interdigitation is compremised, quater crack etc.
    • Like Like x 1
    • Winner Winner x 1
    • List
  19. Offline

    chris bunting Well-Known Member

    Likes Received:
    115
    Trophy Points:
    63
    how would you dress the foot ?
  20. Offline

    gary evans old and slow

    Likes Received:
    215
    Trophy Points:
    43
    Dave is preoccupied in his local hostelry at the moment, but he says that he would trim it level.
    :)

Share This Page

Users Viewing Thread (Users: 0, Guests: 7)