ok........anything to consider when using this shoe? not sure how to ask the Q:........tired have one more to shoe...ask later.
So a deeper bar being better? I'd heard that Darlow had put these on feet after having a bunch from practicing for a contest and no good luck with them, granted I don't know what type of feet they were applied to. Would like to see pics when you go back and reset, if you think of it. Sent from my DROID RAZR using Tapatalk 2
However, my question of the day is how do I address cracks in the foot like the right on here has? The X there is remnant of somebody prior before I started shoeing her.
you did a good job............may I make one suggestion............you need to safe and box the shoe for safety. Ok...
They are, perhaps not enough. Guess I'll get heavier on the rasping. I will admit sometimes I don't do enough when making them at the horse.
Resection is your best bet. I've had a couple grow out with just getting the foot gathered up. Ones like what you have stem from the already weak spot in the toe, let them get long/flared and the leverage will just pry it open. Sent from my DROID RAZR using Tapatalk 2
skunk Josh covered the crack question i probley would have cut a tad less iron ran your inside up and fit the heel or with what you had the shoe needs to come more to the inside then your outside would not look long and your inside would be covered also your clenches are wind swept try clenching them square
Josh when you say resect could you be a bit more specific. Certaily I would debride any necrosis but If the word resect is the same on your side of the pond as ours them what would that achieve?
May be different uses of the word or I might be off in my understanding of it. Clean out the entire crack and explore all tracts till you get to good laminar connection. Debriding is a term I've understood to be dealing with cleaning to good tissue on a wound. Sent from my DROID RAZR using Tapatalk 2
